七彩小精靈沒辦法在 nForce 的主機板上用??

[FrankYang]

事情是這樣的, 自從換了 nForce 的主機板以後
我的七彩小精靈就沒辦法用了
插上 usb 時可以抓得到
可是一但要開始讀取或寫入檔案時
就會說 parameter is incorrect
這時再去讀取該磁碟機時就會要求format
同時七彩小精靈的面板畫面也會凍住
就一個音符會停在畫面中間不動
我用的是 asus 的 a7n8x 主機板
也分別去抓過主機板和七彩小精靈的最新驅動程式了
結果還是一樣
可是如果回到家用 cubx & p3b-f 就都可以正常工作

有網友也遇到一樣的問題嗎?

[lightwing]

nForce2的南橋的USB相容性有問題....
買一塊USB卡吧....
--
我本來要買A7N8X...
後來考慮到這個...改買A7V600

[argentala]

唔 潛水好久了
關於NFORCE2 USB 請看這裡
http://forum.pcdvd.com.tw/showthread.ph ... did=225118
試試看吧 說不定可以解決
解決方法在第36回覆左右..

[FlyNews]

Creative的MP3不支援,連USB Modem也不支援,USB HD不支援,
應該要Email給NVIDIA,把不支援的USB週邊統統列出來,搞不好有幾百項....

nForce2 MCP-T/MCP USB 1.1 Device Compatibility
http://www1.2themax.com/mb_qa/nForce2_M ... ppNote.pdf


This application note addresses the compatibility of the NVIDIA® nForce™ MCP
and the nForce2 MCP-T and MCP processors with several USB devices in the
marketplace. The devices listed below exhibit similar USB non-compliance.

Aztech UM9100-U USB modem
Creative Nomad Muvo MP3 player
Creative Nomad Jukebox Zen MP3 player
SCM video capture device (DCS200)
Sonic Blue Rio S30/35/50 MP3 players
St. Johns Technology USB2 HDD
NuSLIM SUB 2.0 Portable HDD



Proposed Solutions

Several solutions exist depending upon the specific device.

#General Solution

These devices work with MCP/MCP-T if they are behind a USB2.0 hub. Since
the USB2.0 hub reclocks, the jitter is not passed through to the MCP/MCP-T.
This is a general solution for all devices mentioned in this document.

# Sigmatel-Based Devices
Devices that use the Sigmatel STMP3410 part work effectively if a firmware
update is applied. (Please see the respective websites for updated firmware.)
• Creative Nomad MuVo MP3 player